Body Sponsored by
Many questions have recently been posed regarding a story featured by Good Morning America/ABC News regarding the safety of spray tanning. Kelly Richardson of B.Bronz offers her response to the report, and provides some tips and advice when discussing this with clients, employees and others.
The study that was used in the report presented by the media was done by the European Commission Scientific Study on Consumer Safety. This study was published in 2010.
The news media did not differentiate between data that was obtained for automated spray booths and for hand-held turbine devices. The hand-held turbine devices are considered to be safe and do not need/require many of the safety precautions that the automated spray booths require.
The techniques that should be used are designed to minimize dihydroxyacetone (DHA) exposure to the clients. The suggested treatment time consists of less than two minutes of spraying with approximately 50 mL of product. The spray pattern should be designed to push the overspray to the ground, minimizing it and, lastly, it is always recommended that you do not run fans during or after the treatment, as it promotes inhalation. Also recommended is using an extraction fan if you do not have proper room ventilation.
The report by the European Commission shows that high levels of DHA should not be inhaled by either the technician or the client. Most “rapid-developing” products that are on the market have active ingredient levels of 14-22%, which are considered too high for inhalation.